Programing a Zenith converter box remote is an important task that takes a couple minutes to complete and enhances your TV viewing experience by allowing you to remain seated. The entire programing process is done from the remote itself, so there are no tools required and no need to open up your TV. The sooner you program your remote, the sooner you will reap the benefits of having a converter box remote control.
Instructions
1. Press the and hold the "PRG" or (program) button on your Zenith remote. Continue to hold the "PGR" button for 3 seconds, at which time the LED will light up.
2. Press the "Cable" button on the remote so that the remote can assign this button to the converter box. Use the Remote Central website to find the codes list for your converter box. Use the number pad on the remote to type in each digit of the first code, then press "Enter" on the remote.
3. Point the remote at the converter box and press the "Power" button to see if the code worked. The remote programmed successfully If the converter box comes on. If the converter box does not respond, the code did not work and you must repeat the process using another code until you find one that works.
Tags: converter remote
