NuVo Grand Concerto is a complete home audio system that allows you to provide audio files from up to six different sources. Users can connect and use up to eight different systems from the Grand Concerto main console. Connections from each audio station to the back panel of the console are made with CAT5 cables. To reinstall a previously removed NuVo Grand Concerto system, you will need to make new CAT5 cable connections.
Instructions
1. Prepare the NuVo Grand Concerto main console by taking a clean, dry cloth and removing any dust or dirt from the back panel.
2. Strip 3 inches to 4 inches from the end of the CAT5 cable. Twist and fan the wires out, exposing each individual wire.
3. Straighten the wires and place them in this order: green stripe, green, orange stripe, blue, blue stripe, orange, brown stripe and brown.
4. Cut the end of each wire at the same time, using the crimping cutter, making the wires as even in length as possible. Cut enough of the end off so that each wire is about 1/2-inch in length.
5. Hold the wires, still in the proper order, between your thumb and fore finger and slide them into the RJ45 connector, pushing them into the connector as far as they will go without bending them.
6. Place the connector in the crimping tool and push down the handle to tighten the wiring firmly in place.
7. Repeat Steps 2 through 6 for each CAT5 cable you will need, depending on how many connections you need. You will need to prepare both ends of each cable.
8. Connect the amplifier and each audio system to the back panel of the NuVo Grand Concerto console with the CAT5 cables.
Tags: Grand Concerto, back panel, CAT5 cable, NuVo Grand Concerto, will need, audio system
